Motorcycle Drink Holder

At a fuel stop, an overlook, or the first break after a long stretch of road, the bottle you want is usually buried under gloves and a rain layer. This handlebar drink holder gives a slim bottle or cup a fixed place in your cockpit, ready for the moments when the motorcycle is parked.

Ready when the motorcycle is stopped

Before, your drink lives in the luggage and you go digging for it. After, it has a consistent place at the bar. It is a small change, but it cuts one fussy step out of every stop.

Two spring-wire arms, one supported base

The holder uses two stainless spring-wire arms and a ridged lower shelf to steady the container from the sides and below. It is made for narrow bottles and cups with an outside diameter of about 30–77 mm. Measure the widest part of yours before ordering.

Set it up around your ride

Fit the round clamp where it leaves sensible room for switches, cables, and your display. Tighten the mount, then check the fasteners and clearance before every ride. The holder should never interfere with the controls you use most.

Pick the finish that fits your kit

Black, Gray, and Green are all the same holder. Choose the one that sits best with your motorcycle and riding gear.

For rest stops, not moving miles

Use the holder to store and retrieve a drink only after the motorcycle is fully parked. Do not reach for, remove, or drink from the container while riding.

What to check before ordering

• Measure your bottle or cup at its widest point: approximately 30–77 mm outside diameter.
• Plan a handlebar position with full clearance for controls, cables, and display.
• Drink container and motorcycle are not included.